<< Click to Display Table of Contents >> Current:  Data Mart > MPP > Data Mart Management System  Start the MPP Console

In Yonghong MPP mart, every node needs to start the management system by MPP Console, which is a management system independent of MPP mart. In this way, even the mart stops at certain node, this MPP Console can still run normally and detects the abnormal circumstance for each node in the mart. 

Procedures of starting Console and entering in MPP Console: 

1. Start the MPP Console

There are two ways to start:

1)The first way: For nodes with Naming type, start Tomcat/bin/Namingstartupall.sh to start the market management system. Startupall.sh is started for non-Naming type nodes to start the market management system.

2) The second way:

(1)Start the Console Manager: on the Naming Node, run the command  startConsole.sh under installation directory /manager/bin to start Console Manager. 

(2)Start the Console on every node: on every node of data mart, run the command startConsole.sh under installation directory /console/bin to start Console.

For a node with a Naming type, console.port.offset=13 is configured in /console/bin/console.properties by default. This ensures that the ports of the Console Manager and the Console do not conflict and both can start at the same time. Users can manually change the value of the offset.

3. Enter into the MPP Console

From home page -> Manage System -> Audit->Data Mart Console  page, the dashboard at the left of page is divided into three sections:

•Server Manage

•MPP Manage

•Node Manage  The following is the introduction to these three sections.