<< Click to Display Table of Contents >> Current:  System Management  > System Setting  R Configuration

The R calculation configuration is to set up Rserve connection and login authentication for R advanced analytics. 

R calculation configuration interface is as shown in the figure below:

Prior to information configuration, you need to install Yonghong Z-Suite on your local PC, and install R and Rserve on another PC, and start Rserve. Enter the IP address, port, and system of the PC installed with R and Rserve in the "R Configuration" dialog on the local Yonghong Z-Suite. Enter the username and password if required. Then you can analyze data on your local PC using the remote R.

【System】RServe and R support Linux system and Windows. Among them, Linux supports parallel computing; Windows only supports single thread calculation.

【Server Address】Server IP installed on R.

【 Port】The default port is 6311.

【Server Login】When login with name and password are selected, the user and password input boxes will become enterable.

【User】Enter the username to verify the Rserve connection permission.

【Password】Enter the password corresponding to the username.

【Test Connection】Test whether the Rserve is connected successfully.

【Save Connection】Save current settings to connect to R and RServe.